Hub Centric Ring O.D. 130mm I.D. 116mm

One set of 4 hub centric rings with O.D. (outer diameter) of 130mm and I.D. (inner diameter) of 116mm. These rings are made of high quality poly carbon. To determine proper fitment you need to do a couple of things. First you need to determine the center bore size, i.e. O.D. of the aftermarket wheel. Contact your wheel dealer if needed. Then find out the vehicle hub size, i.e. I.D. When these match our hub ring description, then they are the right size. These hub rings will fit the following cars and trucks

• Fits hub of 116mm bore with wheels having 130mm bore

Size:

Fitment and specs

• Outer diameter (O.D.): 130mm, sized for wheels with a 130mm center bore
• Inner diameter (I.D.): 116mm, sized for a 116mm vehicle hub
• Made of high quality poly carbon
• Set of 4, one per wheel

Start with a clean hub and a clean wheel bore so the ring can seat flush. Press each ring into the back of the wheel's center bore, then mount the wheel as you normally would. Once the hardware is snug, the wheel is held dead center on the hub.

Common questions

Why run hub centric rings at all?
Aftermarket wheels often have a center bore larger than the hub they sit over. This ring fills that space, here between a 116mm hub and a 130mm bore, so the wheel is precisely centered for a smooth ride.

Can I reuse the rings when I swap tires?
Yes. They stay seated in the wheel's bore through normal tire service. Check that each one is still flush before the wheel goes back on and press it home if it has moved.