8x6.5/170 Wheel Spacers 7/32" Thick (Pair)
Light aluminum build. They are 7/32" thick. Fit 8x6.5 & 8x170 lug bolt pattern. Please check the thickness of spacers and make sure your lugs and studs on your are long enough. It is recommended that your lug nuts should make at about seven turns when wheels are secured, and that a periodic check be made that they are torqued accordingly. Our application guide page will answer most of your application fitment questions but ask us for unanswered question. Sold in pair.
Size:
Fitment and specs
- Thickness: 7/32 inch
- Bolt patterns: 8x6.5 (8x165.1) and 8x170
- Material: lightweight aluminum
- Sold as a pair, enough for one axle
Clean the hub mounting face, set the spacer flat against it, then hang the wheel on your existing studs. Torque the lug nuts to your vehicle's spec using our torque reference chart, then re-torque after the first 50 to 100 miles. Because the wheel moves out 7/32", check that each lug nut still makes about seven full turns before it seats.
Common questions
Do I need longer studs with a 7/32" spacer?
Only if engagement comes up short. With the spacer and wheel installed, each lug nut should turn roughly seven full times before tightening down. Fewer turns than that means your studs are too short and should be swapped for longer ones first.
Will one pair fit both 8x6.5 and 8x170 hubs?
Yes. These spacers are made to fit both patterns, so the same pair works on an 8x6.5 (8x165.1) or 8x170 hub. Confirm your bolt pattern before installing.