Cragar Style Mag Lug Nut 7/16"-20
7/16" Cragar style standard mg lug nuts including Cragar style washers that fit Cragar SS wheels, etc. These lug nuts fit other custom replacement cast or forged aluminum wheels that are between 11/16" and 7/8" thick at the stud hole. The shank length is 0.75" (19mm) and the total length is 1.57" (40mm). Please refer the following drawing for exact specification and size. Visit our application guide page for any application related information. Contact us for any questions. Sold in each piece.
Size:
Fitment and specs
- Thread size: 7/16"-20
- Style: standard mag shank, Cragar style washer included
- Shank length: 0.75" (19mm), total length: 1.57" (40mm)
- Fits cast or forged aluminum wheels 11/16" to 7/8" thick at the stud hole
- Sold individually, so you can order the exact count your wheels need
Seat the washer flat against the wheel, thread each nut on by hand a few turns, then tighten in a star pattern to your vehicle's spec using our torque reference chart. Confirm the shank sits inside the lug hole without bottoming out before final torque. Re-torque after 50 to 100 miles of driving.
Common questions
Will these work on wheels drilled for conical seat lug nuts?
No. Mag style lug nuts need a straight, flat-bottom lug hole sized for the shank and washer. Conical, ball, and mag seats are not interchangeable, so match the seat your wheel was machined for.
Do I need to buy washers separately?
No. Each lug nut includes the Cragar style washer, made for Cragar SS wheels and similar aluminum wheels between 11/16" and 7/8" thick at the stud hole.