Cragar Style Mag Lug Nut 7/16" Black
7/16" Black cragar style standard mg lug nuts including Cragar style washers that fit Cragar SS wheels, etc. These lug nuts fit other custom replacement cast or forged aluminum wheels that are between 11/16" and 7/8" thick at the stud hole. The shank length is 0.75" (19mm) and the total length is 1.57" (40mm). Please refer the following drawing for exact specification and size. Visit our application guide page for any application related information. Contact us for any questions. Sold in each piece.
Size:
Fitment and specs
- Thread size: 7/16"
- Style: standard mag shank in black, Cragar style washer included
- Shank length: 0.75" (19mm), total length: 1.57" (40mm)
- Fits cast or forged aluminum wheels 11/16" to 7/8" thick at the stud hole
- Priced per piece, so order the count your lug pattern calls for
Place the washer flat in the lug hole, start every nut by hand to avoid cross-threading, then torque in a star pattern to the spec in our torque reference chart. A hand torque wrench on the final pass is easier on the black finish than running an impact to full tightness. Re-torque after 50 to 100 miles.
Common questions
Can I run these on a wheel made for conical or ball seat lug nuts?
No. This is a mag style nut with a shank and washer, and it needs a flat-bottom lug hole. Seat types are not interchangeable, so match the nut to the seat your wheel uses.
How do I know if my wheels are the right thickness?
Measure the wheel at the stud hole. These fit aluminum wheels between 11/16" and 7/8" thick there, with a 0.75" shank reaching through the hole.