Wheel Studs 12mm 1.25 RH 1.5"

Fitment and specs

• Thread size: 12 mm x 1.25 (M12x1.25)
• Thread direction: right-hand (RH), tightens clockwise
• Overall length: 1.5 inches, measured end to end
• Replacement stud for wheel hub mounting

Match this stud to the one coming out before you install it: thread size, pitch, and overall length should all agree, and the knurled section should look the same as the original so the stud seats squarely in the hub. Once the wheel is back on, tighten your lug nuts to the spec in our torque reference chart, then re-torque after 50 to 100 miles.

Common questions

Will my current lug nuts work with these studs?
If they are 12x1.25, yes. Thread size and pitch have to match exactly; a 12x1.5 nut will not thread onto a 12x1.25 stud, and forcing it damages both parts.

How do I confirm 1.5 inches is the right length?
Measure the stud you are replacing from end to end. If it comes out at 1.5 inches overall, this is a like-for-like swap. A stud that is too short cuts down thread engagement, so match the original unless you have a specific reason to go longer.