Wheel Studs 12x1.25x40 DP 14.25mm Nissan
Fitment and specs
- Thread size: 12mm x 1.25, right-hand (RH)
- Overall length: 40mm
- Knurl diameter: 14.25mm
- Spline style, knurled press-fit design
- Nissan fitment, confirm against the stud you are replacing
- Priced per piece, so order the exact count you need
This is a press-fit stud: the 14.25mm splined knurl grips the hub flange, and the head must sit fully flush against the back of the flange before the wheel goes on. Once the wheel is mounted, tighten your lug nuts to the value in our torque reference chart, then re-check them after 50 to 100 miles of driving.
Common questions
How do I confirm this fits my Nissan?
Match three numbers to the stud you are removing: 12mm x 1.25 thread, 40mm overall length, and 14.25mm knurl diameter. The knurl is the ridged section that presses into the hub, and it is the measurement most often missed, so put calipers on the old stud before ordering.
Is this press-fit or screw-in?
Press-fit. The splined end has no threads; it is pressed or drawn into the hub flange and held by the knurl. Only the 12mm x 1.25 end is threaded, and that is where the lug nut goes.